FPI I2450M Manual page 312

HI300
installation
|
16
5) Slowly slide the Mantel Top forward until it stops.
6) Place supplied gasket to bottom edge of top faceplate - continue
gasket up each side at a 45° angle.
7) Mount the Top Faceplate by carefully sliding the Mounting Plates on
the Left and Right Side Faceplate through the Retainers in the Top
Faceplate.
NOTE: Slowly lower the Top Faceplate into position; being careful
not to damage the Mantel Top.
NOTE: Installing the top faceplate will require 2 people - it is
heavy and awkward to handle.
Retainer
Mounting Plates
Right Side Face-
plate
Backside of Unit & Faceplate Shown.
16 |
Regency HI2450M
918-967
Slide Mantel Top
Top Faceplate
Gasket Location
Left Side Faceplate
8) Carefully slide the Mantel Top back into position.
Slide Mantel
Top back.
9) Adjust Left Side Faceplate and tighten bolts. Repeat step for Right
Side Faceplate.
10) Location of Insulation:
a) Place 1 piece of Insulation behind the Mantel Top.
b) Cut the second piece of Insulation in half, then install behind both
the Left and Right Sides as shown.
11) The unit may now carefully be slid into f i nal position.
See side cast adjustments if faceplate needs aligning.
2
Insulation
05/02/11