FPI I2450M Manual page 310

installation
|
14
8) Location of Insulation:
a) Place 1 piece of Insulation behind the Mantel Top.
b) Cut the second piece of Insulation in half, then install behind both
the Left and Right Sides as shown.
9) The unit may now carefully be slid into f i nal position.
918-300g
14 |
Regency HI2450M
CAST FACEPLATE
INSTALLATION
Insulation
Page 3 of 3
RECOMMENDED MEASUREMENTS
FOR SETTING SIDE CASTS
Stop! Read Carefully.
Enamel & Cast components are very fragile.
Use extreme care when handling.
1/4" (approx.) between both
sides of door and cast.
Left Side
Cast
1/8" - 1/4" (approx.) for both sides,
between ashlip and bottom of side cast.
Rear View of Unit
4-1/2" - 4-3/4" boths sides rear inside edge to f i rebox.
Important: Verify gap between cast and door did not
change when rear adjustments have been made.
Carefully open door slowly, to ensure that the door does
not rub against cast sides.
*
These are just recommended measurements.
HI300
Right Side
Cast
12/23/10