Fan Installation - FPI FP90 Owners & Installation Manual

INSTALLATION
NOTE: If optional Ashtray is installed, it must be removed before installing the fan.
1) Remove the thumb screw from the fan transfer tray.
2) Slide fan transfer tray fully out through the bottom louver opening.
3) Mount the fan bracket onto the fan transfer tray using the two locating pins.
4) Slide the Control Box onto the Control Box Mounting Bracket located on the front of the fan transfer tray and secure with
the #8 x 3/8" screw provided (refer to Diagram 1).
5) Install the wiring as shown on the wiring diagram. Use the strength relief for running the wires from the fan transfer tray to
the receptacle box or the ground screw (refer to Diagram 2).
FAN 910-175
AX-3088
THERMODISC 910-142
60T12
6) Slide the fan transfer tray back into the unit and hook up wires to the Control Box and mount the thermo disc in place.
22

FAN INSTALLATION

The receptacle Box must be wired for the fan cable to be plugged into.
Diagram 1
910-903
910-516
NEUTRAL - FROM FAN
910-896
Diagram 2
GROUND
VARIABLE SWITCH 910-330
POWER CORD 910-519
GROUND
FPI FP90 Wood Fireplace