FPI I2450M Manual page 309

4) Slowly slide the Mantel Top forward until it stops.
5)
Mount the Top Faceplate by carefully sliding the Mounting Plates
on the Left and Right Side Faceplate thru the Retainers in the
Top Faceplate.
NOTE: Slowly lower the Top Faceplate into position; being careful
not to damage the Mantel Top.
6) If unable to align side faceplate to unit and top
faceplate further adjustments need to be made, complete
one side at a time. Loosen all bolts on brackets (6 per side).
Loosen top and bottom bolts (Shown below).
Adjust left or right side cast plates to allow further adjustment
on faceplate. Once aligned, hold side surround in place and
tighten all bolts. If side cast height needs adjusting, loosen 2
bolts holding cast bracket and adjust up or down
Cast
mounting
bolts
for height
adustment.
See Step 3 to identify side casts.
See next page for recommended measurements.
918-300g
CAST FACEPLATE
INSTALLATION
Slide Mantel
Top
.
Cast
adjustment
bolts
Page 2 of 3
Retainer
Mounting Plates
Right Side
Faceplate
Backside of Unit & Faceplate Shown.
7) Carefully slide the Mantel Top back into position.
Slide Mantel
Top back.
installation
HI300
Top Faceplate
Left Side
Faceplate
12/23/10
Regency HI2450M
|
13
| 13