Add/Edit Static Multicast Forwarding By Mac - ZyXEL Communications XMG1915 Series User Manual

40.2.1 Add/Edit Static Multicast Forwarding By MAC

Use this screen to add a static multicast MAC address rule for ports to receive the multicast stream.
Click Add/Edit, or select an entry and click Add/Edit in the SWITCHING > Multicast > Static Multicast
Forwarding By MAC to display this screen.
Figure 162 SWITCHING > Multicast > Static Multicast Forwarding By MAC > Add/Edit
The following table describes the labels in this screen.
Table 120 SWITCHING > Multicast > Static Multicast Forwarding By MAC > Add/Edit
LABEL
Active
Name
MAC Address
VID
Port
Apply
Clear
Cancel
Chapter 40 Static Multicast Forwarding
DESCRIPTION
Enable the switch button to activate your rule. You may temporarily deactivate a rule without
deleting it by disabling the switch.
Enter a descriptive name (up to 32 printable ASCII characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ]) for
this static multicast MAC address forwarding rule. This is for identification only.
Enter a multicast MAC address which identifies the multicast group. The last binary bit of the first
octet pair in a multicast MAC address must be 1. For example, the first octet pair 00000001 is 01 in
hexadecimal, so 01:00:5e:00:00:0A and 01:00:5e:00:00:27 are valid multicast MAC addresses.
You can forward frames with matching destination multicast MAC address to ports within a VLAN
group. Enter the ID that identifies the VLAN group here. If you do NOT have a specific target
VLAN, enter 1.
Enter the ports where frames with destination multicast MAC address that matched the entry
above are forwarded. You can enter multiple ports separated by (no space) comma (,) or
hyphen (-). For example, enter "3-5" for ports 3, 4, and 5. Enter "3,5,7" for ports 3, 5, and 7.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XMG1915 Series User's Guide
230