Xerox Document Binder 120 Operator's Manual page 84

PREPARING THE BINDER 120 FOR ON-LINE AND OFF-LINE OPERATION
3-16
CAUTION: You must maintain the proper alignment with the host
machine at all times. If you do not maintain the proper alignment, the
Binder 120 either may not receive the copy sets at all or may receive
them improperly. Improperly received copy sets could result in input
jams in the Interface Module.
15. Move the Binder 120 toward the Output Tray of the host machine
so that the cutout corner of the Alignment Bracket is flush with
the right front corner of the host machine.
•
NOTE: When the Binder 120 is in the proper position, the
Alignment Bracket will fit snugly against the host machine.
However, the machines will not be at a 90-degree angle with
each other. The actual angle of alignment will be slightly greater
than 90 degrees.
0312075B-SBR
16. Rotate the Receiving Plate down until it rests on the Output Tray
of the host machine.
0312076A-SBR
Use the arrows and raised green edging around the cutout
corner as an aid in positioning the Binder 120.
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL