Table of Contents
Advertisement
PROBLEM SOLVING
7-6
Areas 3A, 3B, 3C
To clear a jam in areas 3A, 3B or 3C, do the following:
1.
Read the instructions in the Message Display.
2.
Use the Mimic Display to locate the jam.
3.
Open the Right Front Door.
CAUTION: Be careful not to pull on the Book String Guides when
removing jammed books.
4.
Follow the instructions on the jam clearance label(s) to remove
the book and any obstruction.
NOTE: Any books removed during this jam clearance operation
have completed the binding process. If they are undamaged,
store them with your other completed books.
CAUTION: Close the Right Front door as soon as you clear the
jam. If you leave the door open too long, any books waiting in the
0312058B-SBR
Binder Module area will overheat. This will result in defective binding
and warped books.
5.
Close the Right Front Door.
6.
Do one of the following:
a.
b.
7.
Read the instructions in the Message Display.
a.
b.
If the Binder is in the on-line mode, proceed to step 7.
If the Binder is in the manual mode, insert the next copy
set or copy set with cover into the Manual Feeder and
press the Manual Start button. Ignore the remaining steps
in this procedure.
Xerox 5100 or 5680/5892
?
If a copy set was delivered to the Output Tray of the
host machine, the indicator light for the selected Cover
Tray will flash and the Message Display will instruct
you to press Reset. After you do so, a second
message will instruct you to press Manual Start.
NOTE: Once you press Manual Start, the Binder 120
will accept the copy set and bind it into a book. The
Binder 120 is now ready for normal binding operation.
?
If no copy set was delivered to the Output Tray of the
host machine, the Message Display will advise you
that the Binder 120 is ready to bind.
Xerox 5800, 5890 or 5895
The Message Display will advise you that the Binder 120 is
ready to bind.
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
Advertisement
Table of Contents
