Table of Contents
Advertisement
PROBLEM SOLVING
Condition
Cover Tray 1or Cover Tray 2 will not
close.
Binder 120 displays a message that
Cover Tray 1 and Cover Tray 2
contain different cover types.
Desired Cover Tray is unlocked and
cannot be selected.
Binder 120 displays a message
about required spine width.
Binder displays a message
instructing you to feed a set using a
Xerox cover.
Books are bound on wrong edge of
copy sets.
7-16
Causes
The Cover Tray does not contain a
cover cassette.
1&2 has been selected from the
Control Panel of the Binder 120, but
the Cover Trays contain different
cover types.
The cover cassette in the Cover Tray
is empty.
The required spine width for the
current copy set is not the same as
the spine width for the selected
Cover Tray.
A non-Xerox cover type is being
used.
The cover sensor cannot detect the
Xerox cover because the cover is
deformed.
Auto feed:
The documents were placed
incorrectly into the Document Feeder
of the host machine.
Manual feed:
The copy sets were fed incorrectly
into the Manual Feeder of the Binder
120.
Suggested solutions
Load an empty cassette or a
cassette containing covers into the
Cover Tray.
Load the appropriate cover cassettes
into both Cover Trays or select Cover
Tray 1 or Cover Tray 2.
Load a cassette containing covers
into the Cover Tray.
Load a cover cassette containing the
correct cover spine width into the
selected Cover Tray.
Clear the jam as directed in the
"Locating and clearing a jam" section
of this chapter.
Load a cover cassette containing
Xerox covers into the selected Cover
Tray or insert a copy set with a
Xerox cover into the Manual Feeder.
Clear the jam as directed in the
"Locating and clearing a jam" section
of this chapter.
Straighten the cover spine.
Auto feed:
See the operator manual of the host
machine for correct orientation of the
documents.
Manual feed:
Insert copy sets into the Manual
Feeder as directed in chapter 4,
"Making the books."
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
Advertisement
Table of Contents
