Xerox Document Binder 120 Operator's Manual page 7

XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
3. Preparing the Binder 120 for
on-line and off-line operation
This chapter describes the modes of operation of the Binder 120. It
also explains how to set up the Binder 120 for both on-line
(automatic) and off-line (manual) operation. It includes procedures for
the following situations:
•
Connecting to a host machine
Use this procedure to connect the Binder 120 to a host machine.
After doing so, the Binder 120 will be in the on-line mode for
automatic binding of books.
•
Disconnecting from a host machine
Use this procedure to disconnect the Binder 120 from a host
machine. After doing so, the Binder 120 will be in the stand-
alone mode for manual binding of books.
•
Switching to a different host machine
Use this procedure to disconnect the Binder 120 from one host
machine and connect it to a different one. After doing so, the
Binder 120 will remain in the on-line mode for automatic binding
of books.
•
Switching from on-line to stand-by mode
Use this procedure to disconnect the Interface Module of the
Binder 120 from the Output Tray of the host machine. After
doing so, the Binder 120 will remain in the on-line configuration,
but will be in the stand-by mode. Both machines can then
operate independently.
•
Switching from stand-by to on-line mode
Use this procedure to connect the Interface Module of the Binder
120 to the Output Tray of the host machine. After doing so, the
Binder 120 will be in the on-line mode for automatic binding of
books.
3-1