Table of Contents
Advertisement
CUSTOMIZING YOUR BINDER 120
Customer Tools feature
Security Code
Software Version
5-6
1.
Enter the Customer Tools mode as instructed in the previous section of this
chapter.
2.
Press the New Job button until Change Code appears on the second line of
the Cover Supply Contents Display.
3.
Press the Manual Start button to accept Change Code.
CAUTION: Be certain to record your five-button entry somewhere, because the
buttons you press and the order in which you press them will become your new
Security Code.
4.
Enter a new five-button Security Code.
NOTE: You can use any combination of the Language, Reset, Energy
Saver, Stop, and New Job buttons. You cannot use the Manual Start
button.
5.
Press the new five-button Security Code a second time for verification.
NOTE: If your second entry does not match your first, a message will advise
you that the Security Code is not the same. Press the Manual Start button
to begin the feature again.
6.
Do one of the following:
•
Press the New Job button until the next feature you want to change
appears on the second line of the Cover Supply Contents Display.
•
Press the Reset button to exit the Customer Tools features.
1.
Enter the Customer Tools mode as instructed in the previous section of this
chapter.
2.
Press the New Job button until Software Version appears on the second
line of the Cover Supply Contents Display.
3.
Press the Manual Start button to accept Software Version.
NOTE: The software version level of the Main Board EPROM and UI Board
EPROM will appear in the Cover Supply Contents Display. This information is
read-only.
4.
Press the Stop button to exit the Software Version feature.
5.
Do one of the following:
•
Press the New Job button until the next feature you want to change
appears on the second line of the Cover Supply Contents Display.
•
Press the Reset button to exit the Customer Tools features.
What to do
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
Advertisement
Table of Contents
