Xerox Document Binder 120 Operator's Manual page 46

Customer Tools feature
Attention Lamp and Sound
Tone
Electronic Counter
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
1. Enter the Customer Tools mode as instructed in the previous section of this
chapter.
2. Press the New Job button until Lamp and Tone appears on the second line
of the Cover Supply Contents Display.
3. Press the Manual Start button to accept Lamp and Tone.
4. Press the New Job button to display the desired Lamp setting.
NOTE: You can select "enabled" or "disabled." Pressing the New Job button
enables you to switch between the two choices.
5. Press the Manual Start button to display the desired Tone setting.
NOTE: You can select "enabled" or "disabled." Pressing the Manual Start
button enables you to switch between the two choices.
6. Press the Stop button to save the settings and exit the Lamp and Tone
feature.
7. Do one of the following:
•
Press the New Job button until the next feature you want to change
appears on the second line of the Cover Supply Contents Display.
•
Press the Reset button to exit the Customer Tools features.
1. Enter the Customer Tools mode as instructed in the previous section of this
chapter.
2. Press the New Job button until Counter appears on the second line of the
Cover Supply Contents Display.
3. Press the Manual Start button to accept Counter.
4. Press the New Job button to proceed with the Counter reset.
5. Press the New Job button again to confirm the Counter reset.
6. Press the Stop button to save the setting and exit the Counter feature.
7. Do one of the following:
•
Press the New Job button until the next feature you want to change
appears on the second line of the Cover Supply Contents Display.
•
Press the Reset button to exit the Customer Tools features.
CUSTOMIZING YOUR BINDER 120
What to do
5-5