Table of Contents
Advertisement
How to change the Customer Tools features
United States
Entering the Customer Tools mode
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
The buttons on the right side of the Control Panel on the Binder 120
enable you to enter the Customer Tools mode and change the
features. For assistance with the location of these buttons, refer to
the illustrations below.
0312068A-SBR
To change the Customer Tools features, first use the instructions on
this page to access the Customer Tools features. Then use the
instructions on the following pages to change the settings for the
desired features.
To enter the Customer Tools mode, do the following:
1.
Simultaneously press and release the Energy Saver and Stop
buttons.
The Message Display and Cover Supply Contents Display will
now contain instructions for accessing the Customer Tools.
2.
Do one of the following:
a.
If the security code has not been changed, enter the default
security code by pressing the Language button five times.
b.
If the security code has been changed, enter the current
five-button security code.
NOTE: For security, the code you enter will display as
asterisks.
3.
Press the Manual Start button.
You are now ready to select and change the desired Customer
Tools feature. The features display one at a time on the second
line of the Cover Supply Contents Display. Pressing the New
Job button enables you to cycle through the features menu.
Energy Saver is the default selection each time you enter the
Customer Tools mode.
To change the features, refer to the instructions that follow.
CUSTOMIZING YOUR BINDER 120
Xerox Limited/Xerox Canada Limited
0312067A-SBR
5-3
Advertisement
Table of Contents
