Xerox Document Binder 120 Operator's Manual page 68

XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
CAUTION: You must maintain the proper alignment with the host
machine at all times. If you do not maintain the proper alignment,
the Binder 120 either may not receive the copy sets at all or may
receive them improperly. Improperly received copy sets could
result in input jams in the Interface Module.
12. Move the Binder 120 toward the Output Tray of the host machine
so that the cutout corner of the Alignment Bracket is flush with
the right front corner of the host machine.
•
NOTE: When the Binder 120 is in the proper position, the
Alignment Bracket will fit snugly against the host machine.
However, the machines will not be at a 90-degree angle with
each other. The actual angle of alignment will be slightly greater
than 90 degrees.
0312086B-SBR
13. Rotate the Receiving Plate down until it rests on the Output Tray
of the host machine.
0312087A-SBR
WARNING: If you are wearing open-toe shoes, be careful when
pressing the Lock Levers.
14. Lock at least two of the Binder 120 Casters by pressing with
your foot on the gray Lock Lever of the Casters.
PREPARING THE BINDER 120 FOR ON-LINE AND OFF-LINE OPERATION
Use the arrows and edging around the cutout corner as an
aid in positioning the Binder 120.
3-51