Table of Contents
Advertisement
CUSTOMIZING YOUR BINDER 120
Changing the Customer Tools features
Customer Tools feature
Energy Saver
Spine Width Units Display
5-4
The table below contains the steps for changing each of the
Customer Tools features.
1.
Enter the Customer Tools mode as instructed in the previous section of this
chapter.
2.
Press the Manual Start button to select Energy Saver from the second line
of the Cover Supply Contents Display.
NOTE: Energy Saver is the default selection each time you enter the
Customer Tools mode.
3.
Press the New Job button until the desired Hours setting is displayed.
NOTE: You can select from 0 to 12. As you press the New Job button, the
hours increment by one until you reach 12. The cycle then begins again at 0.
NOTE: If 0 hours and 0 minutes are selected, the timed Energy Saver mode is
disabled.
4.
Press the Manual Start button until the desired Minutes setting is displayed.
NOTE: You can select 0, 15, 30 or 45. As you press the Manual Start button,
the minutes increment by 15 until you reach 45. The cycle then begins again
at 0.
5.
Press the Stop button to save the settings and exit the Energy Saver feature.
6.
Do one of the following:
•
Press the New Job button until the next feature you want to change
appears on the second line of the Cover Supply Contents Display.
•
Press the Reset button to exit the Customer Tools features.
1.
Enter the Customer Tools mode as instructed in the previous section of this
chapter.
2.
Press the New Job button until Units appears on the second line of the Cover
Supply Contents Display.
3.
Press the Manual Start button to select Units.
4.
Press the Manual Start button to display the desired Units measurement.
NOTE: You can select "inch" or "metric." As you press the Manual Start
button, you will switch between the two choices.
5.
Press the Stop button to save the setting and exit the Units feature.
6.
Do one of the following:
•
Press the New Job button until the next feature you want to change
appears on the second line of the Cover Supply Contents Display.
•
Press the Reset button to exit the Customer Tools features.
What to do
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
Advertisement
Table of Contents
