Xerox Document Binder 120 Operator's Manual page 111

Switching to a different host machine
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
PREPARING THE BINDER 120 FOR ON-LINE AND OFF-LINE OPERATION
You can connect the Binder 120 to any compatible host machine,
provided the host machine is equipped with the appropriate Copier
Enablement Kit. The kit allows you to connect an Interface Cable
between the Binder 120 and the host machine.
If your host machine is not equipped with a Copier Enablement Kit,
contact your Xerox Sales Representative by calling the number that
you recorded in chapter 1, "Introduction."
To disconnect the Binder 120 from one host machine and connect it
to a different one, do the following:
1. Perform steps 1 to 14 from the procedure entitled "Disconnecting
from a host machine" discussed earlier in this chapter.
NOTE: Once you lower the Interface Module all the way down to
the left side of the Binder 120, you will not need to perform any
further steps in the procedure. The remaining steps prepare the
Binder 120 for the stand-alone mode.
2. Locate the section of this chapter that provides the procedure for
connecting to the applicable host machine.
3. Begin with step 3 and follow the procedure to the end.
3-43