Table of Contents
Advertisement
GETTING TO KNOW THE BINDER 120
Output Tray and Book Guide
2-10
The Binder 120 delivers the bound books to its Output Tray, which is
located on the right side of the top of the Binder 120. The Book
Guide serves as a bookend to hold the books in place in the Output
Tray. The Book Guide moves to the left as the books arrive in the
Output Tray.
When the Output Tray is approximately half full, the message
"Empty Top Output Tray" will appear in the Message Display of the
Binder 120 Control Panel. If enabled, the Attention Lamp will light
and the Sound Tone will beep twice. The Binder 120 will continue to
operate.
When the Output Tray is approximately three-quarters full, the
message "Output Tray Almost Full - Empty Top Output Tray" will
appear in the Message Display of the Binder 120 Control Panel. If
enabled, the Attention Lamp will light and the Sound Tone will beep
twice. The Binder 120 will finish binding the copy sets in process,
but will not accept any new sets. To continue feeding sets to the
Binder 120, you must empty the Output Tray of both the Binder 120
and the host machine. You then must restart the host machine.
When the Output Tray is full, the Binder 120 will shut down. The
message "Output Tray Full - Empty Top Output Tray " will appear
in the Message Display of the Binder 120 Control Panel. If enabled,
the Attention Lamp will flash and the Sound Tone will beep every two
seconds. To continue feeding sets to the Binder 120, you must
empty the Output Tray of both the Binder 120 and host machine.
You then must reset the Binder 120 and restart the host machine.
Below is an illustration of the Output Tray and Book Guide.
2
1
1.
Output Tray
2.
Book Guide
3.
Books
XEROX DOCUMENT BINDER 120 OPERATOR MANUAL
3
2
1
0312008C-SBR
Advertisement
Table of Contents
