Table of Contents
Advertisement
Copy Reduc Rate: 75%
Program/Enter
5
Press
to save the setting. The
ENTER
reduction margin:
Copy Reduc Rate: 75%
Margin(0-85mm):
If the setting you see is acceptable, skip to step 7.
Otherwise, proceed to step 6.
6
To change the setting, use the numeric keypad to enter the reduction margin
you want. If necessary, press
example, we've chosen 00mm.
Copy Reduc Rate: 75%
Margin(0-85mm):
7
Press
to save the setting.
ENTER
Setting the number of rings
You can set how many times your fax machine will ring before answering a call.
You may choose one to nine rings.
1
Press
,
, 0, 6,
PROGRAM
J
ENTER
Set # Of Rings
#
(1-9):
If the setting you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2
To change the setting, use the numeric keypad to enter the desired number of
rings, from one to nine. Here, we've chosen four rings.
Set # Of Rings
#
(1-9):
Note: If you enter 0 (zero), the machine will beep briefly to warn you that it
can't accept that setting.
3
Press
to save the setting.
ENTER
shows the current setting for the
LCD
24
or
to move the cursor if you need. In this
00
. The
will show:
LCD
2
4
Setting
ECM
Ever hear static on the line during a phone call? It's a real nuisance — but, worse, it
may ruin your attempts to communicate via fax. This is because "line noise" can
easily disrupt the flow of data from one fax machine to another.
That's why your fax machine gives you the chance of operating in Error Correction
Mode (
). When two fax machines communicate while running in
ECM
ing machine automatically checks the data, "block" by "block," as it sends. If the
receiving fax machine can't verify the transmission, the first machine will re-send
as necessary. (Essentially, the sending machine asks, "Did you 'hear' that seg-
ment?" and the other machine answers either "Yeah; go on" or "No; try it again.")
Note: While using
gives you a better chance of getting a fax document
ECM
through a troublesome phone line, it also could slow down the transmission
time — and increasingly so in proportion to how bad the phone line is.
That's why we let you turn
ECM
Note: Not all fax machines have
ECM
a fax machine not currently using
transmission from a usual, non-
1
Press
,
, 0, 8,
PROGRAM
J
ENTER
ECM Mode:
On
Program/Enter
If the setting you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
2
To change the setting, press
PROGRAM
appears. In this example, we've chosen Off.
ECM Mode:
Off
Program/Enter
3
Press
to save the setting.
ENTER
Beyond the basics
ECM
on or off as you require.
. If you've activated
and then transmit to
ECM
, there will no change in the fax
ECM
transmission.
ECM
. The
shows the current
setting:
LCD
ECM
once or twice until your chosen setting
, the send-
2.5
Advertisement
Table of Contents
