X85; Staple-Type Target Mask - Konica Minolta CM-23d Instruction Manual

… Staple-Type Target Mask

„
Using the optional stapler type target mask (CM-A268) makes it possible to accurately aim where measurement
will be performed.
„ Attaching the Target Mask
„
Attach the stapler type target mask so that the two protrusions of the target mask are inserted into the 2 holes
on the bottom of the instrument, and push in until the tab on the rear end of the target mask catches on the
instrument and clicks.
Stapler type target mask
CM-A268
Memo
• Secure the target mask by tightening screws into the mounting screw holes for accessories on the instrument (refer
to P.16).
• Use any of the following screws to secure the target mask.
① CM-A280 (Stapler type target mask coupling screws)
② Screws with the following dimensions: M3 (thread size) × 4 mm (length) × Ø5.5 to 6 (head diameter) × 2 mm or
less (head height)
Notes
Using screws other than the above may result in damage to the instrument or the target mask, scratches on
the measurement sample, or incorrect measurement values.
„ Attaching/Removing the Target Sheet
„
1.
Attach a target sheet to the stapler type target
mask.
2.
Align the notch and rotate in the direction indicated
by the arrow.
3.
The sheet will be locked when a "click" is heard.
• Perform the procedure in reverse to remove.
33
Align
Click
Push down slowly
MAV (Ø8 mm)
CM-A270
Turn
Click