Attaching A Target Mask; Notes On Use Of Target Mask - Konica Minolta CF-300 Instruction Manual

Attaching a Target Mask

WARNING
Do not place the CF-300 on an unstable or sloping surface. Doing so may result in its falling
or overturning, causing injury. Take care not to drop the CF-300 when carrying it.
Be careful not to pinch hands in parts of the instrument or accessories
that open and close. Doing so may result in injury.
The CF-300 allows you to select a target mask according to the specimen and your application.
Memo
Use the same target mask that you are using or plan to use in measurements
when calibrating the instrument's zero-point and white sensitivity.
Procedure
1
. Position the instrument so as to pull the
currently attached target mask to the front and
detach the mask.
Memo
The target mask attaches to the
instrument by way of a magnet.
2
. With target mask detection pin downward,
align it with the main body hole, align the
positioning holes on the target mask with
the target mask positioning pins on the
instrument, and attach the target mask to the
instrument.
Note
When using the instrument by incorporating it into
equipment, secure the target mask to the instrument in
two places with the target mask mounting screw.
Memo
Tighten the screws with a 2 mm hex key.

Notes on Use of Target Mask

c Take care not to scratch or make the inner surface (white-coated surface)
of the target masks dirty with such as fingerprints.
c Take care to avoid scratching the target mask detection pin on the inner surface
(white-coated surface) of the target mask or getting it dirty.
c The target masks may become discolored if left in areas exposed to light. Therefore, make sure that target
masks which are currently not in use are kept inside the accessory case (CF-A25) to prevent exposure to light.
c When not using the CF-300, attach one of the target masks or the protective
cap to prevent dust entering the integrating sphere.
c Take care not to leave the CF-300 for a long period of time with a target mask
attached. The sample holder may stick to the target mask.
16
Target mask
positioning holes
Target mask
detection pin
Mounting
screws