Konica Minolta CM-23d Instruction Manual page 135

Caution: The setting or operation is not correct.
Data is outside the range of guaranteed performance.
The target is protected.
Cannot be used in the current mode.
The date is incorrect.
The target mask is wrong.
The target mask diameter is incorrect. Install the target mask correctly.
The set tolerance range is incorrect. Please check the upper and lower limits.
Please retry the measurement.
Press the measurement button to measure and update to the most recent data.
The sample variation exceeds the threshold. Measure again.
This target number is linked to opacity data.
This sample cannot be based on the selected target.
The data could not be calculated.
The input data is incorrect.
You have reached the maximum number of possible measurements.
No target was found.
Only administrators can control this function.
Display: The flow of operation is displayed. Perform the operation according to the information displayed.
Perform zero calibration.
Please set the instrument on the zero calibration box and calibrate.
Perform white calibration.
Please set the instrument on the white calibration plate and calibrate.
Configure the white calibration data.
Please change the measurement area.
Please close the viewfinder.
Specify at least one.
Calibration is required. Would you like to calibrate now?
The device memory is full. Please delete some data to measure.
Data is being saved. Please wait until the power turns off.
Data is being processed. Please wait.
Regularly scheduled device calibration is required. Please contact the nearest service
center.
Regularly scheduled device calibration is approaching. Please contact the nearest service
center.
Calibration is recommended. Would you like to calibrate now?
See P.65
See P.102
P.68 and 74.
See P.99
See P.34
See P.34
See P.36
See P.36
See P.36
See P.38
See P.34
P.39 and 51.
See P.125
See P.125
P.34 and 124.
132
5