Connecting Via Bluetooth; Instrument Preparation; Connecting The Bluetooth Module - Konica Minolta CM-23d Instruction Manual

z Connecting via Bluetooth
„
Connect the instrument to a printer with Bluetooth communication functionality using the optional Bluetooth
module.
Notes
• The instrument's Bluetooth function enables data communication with a connected computer and printing
from a Bluetooth printer. Connecting to both a computer and a printer/barcode reader at the same time,
however, is not possible.
• A simultaneous connection via the USB cable and the Bluetooth function is not possible. Should both
connections be established at the same time, priority will be given to the connection via USB cable.
Memo
To connect the instrument to a computer via the Bluetooth function, appropriate preparations for Bluetooth
communication must be performed in advance for both the instrument and the printer.

{ Instrument Preparation

„
Connect the optional Bluetooth module CM-A219.
Turn ON the instrument's Bluetooth function and configure the PIN code on the instrument as required.

• Connecting the Bluetooth Module

Operating Procedure
1
Slide open the instrument's battery cover and attach the Bluetooth module.
Notes
When inserting the Bluetooth module, please note that
the module will be slightly loose. Pushing forcibly on the
module may damage the connector if the module and the
connector on the instrument are not aligned correctly.
The module and the connector on the instrument will be
aligned correctly if the line on the side of the module is
no longer visible when the module is dropped into the
slot. Push the module in from this position until it clicks
(approx. 1 mm).
2
Slide the battery cover to close it.
113
A line can be seen on
the side of the module.
Insert with the orientation
aligned to this position.