Attaching/Removing The Target Mask - Konica Minolta CR-10 Plus Instruction Manual

Handling the Instrument

Attaching/Removing the Target Mask

The following procedure explains how to attach or remove the target mask.
Notes • Take care to prevent dust or the like from entering the integrating sphere from the sample surface aperture during operation.
• Do not touch the inside surface of the integrating sphere painted white, use a cloth to wipe off dust or dirt, or put anything inside.
• Do not apply excessive force to latch portion on the inside of the target mask. The target mask may become unusable if the latch portion is damaged.
• If the target mask is damaged, contact a KONICA MINOLTA-authorized service facility.
Attaching to/Removing from Instrument
Mark
(Cont.)
CR-10 Plus
Target mask
Attaching
❶
Apply the target mask so that the
protrusions on the outer perimeter of the
target mask are aligned with the starting
point of the mark used for aligning the
instrument.
❷
Hold the outer perimeter of the target mask,
and rotate in the direction of the arrow
(clockwise). Turn the target mask until the
protrusion on the outer perimeter aligns with
the | mark on the instrument and a clicking
sound is heard. The target mask will be
secured.
Removing
❶
Hold the outer perimeter of the target mask,
and rotate in the opposite direction of the
arrow (counterclockwise) to remove the
target mask. Rotate the mask until the
protrusion on the outer perimeter reaches
the starting point of the mark used for
aligning the instrument.
❷
Hold the outer perimeter of the target mask
to remove it.
15