X85; Auto Average (1 To 10) - Konica Minolta CM-23d Instruction Manual

… Auto average (1 to 10)

„
Specify the number of measurements for auto averaging. Every time the measurement button is pressed, the
average of the data obtained from the specified number of continuous measurements is determined as sample
data.
Memo
"1" is set as the number of measurements for automatic averaging when the instrument is shipped from the factory.
Operating Procedure
1
Use [▲] or [▼] to move the cursor to "Auto average",
and then press the [Confirmation] key.
2 ▲ and ▼ will be displayed above and below the
count in the count selection. Use [▲] or [▼] to
specify a value.
Settings
{ 1 to 10 times:
Specify the number of measurements, from 1 to 10, to
perform when using auto averaging.
3
Press the [Confirmation] key.
The selection is confirmed and the screen returns to the
<Measurement setup> screen.
Notes
If [ESC] is pressed without pressing the [Confirmation]
key, the settings will not be changed and the screen will
return to the <Measurement setup> screen.
87
Start the procedure from the <Measurement cond.> - <Measurement setup> screen.