Connecting Via Usb Cable - Konica Minolta CM-23d Instruction Manual

z Connecting via USB Cable
„
Connect the instrument to a computer with the supplied USB cable IF-A28 (2 m).
Notes
• To connect the instrument to a computer, the dedicated USB driver must be installed. The necessary drivers
will be installed automatically. To install the drivers manually, use the drivers included with the software
(such as the optional SpectraMagic NX software).
• The instrument can be powered through the USB cable. (The battery must always be installed.)
• When power is being supplied via USB, the charging lamp on the instrument's panel will light up orange
while charging. When charging is complete, the lamp will turn green.
• Firmly connect the USB connector plug in the correct orientation.
• When connecting/disconnecting the USB cable, be sure to hold the connector plug. Do not pull on or forcibly
bend the cable. Otherwise, wire breakage may result.
• Connect the instrument using a cable with a suitable length. Putting tension on the cable may cause
connection failure or wire breakage.
• Firmly push in the USB cable connector that matches the shape of the port (connection terminal) until it can
go in no further.
Memo
The USB communication port of the instrument conforms to
USB 2.0.
Operating Procedure
1
Open the connector's protective cover, and connect
the USB cable mini plug to the USB port on the
instrument.
◆ Fully insert the connector and ensure the connection is
secure.
2
Connect the A connector of the USB cable to the USB
port on the computer.
3
Turn the instrument power ON.
◆ When installation of a USB driver is prompted, specify
the USB driver included with your PC software to
complete the installation.
4
112