Displaying The Measurement Results; X85; <Sample> Detail Screen: Absolute Value - Konica Minolta CM-23d Instruction Manual

„ Displaying the Measurement Results
At the end of measurement, the measurement results will be displayed on the LCD according to the specified
conditions. Typical measurement result screens are shown below.
You can switch the tab of the measurement screen with the ◀ or ▶ of the cross key.
Memo
You can switch the sample No. with the ▲ or ▼.
… <Sample> detail screen: Absolute value „
① Specular component mode used for the measurement
② Current UV setting (UV 0% only)
③ Current measurement area (Ø8 mm only)
④ Calibration completed
⑤ Automatic printing from serial printer set to ON (OFF when the icon is not displayed)
⑥ Current time
* For details of the status bar items ① to ⑥, refer to P.22.
⑦ Target/Sample
⑧ No. of the currently selected color difference target data
⑨ Pass/fail judgment (When the result is "Pass", the background is shown in green. When the result is "Fail", the
background is shown in orange.)
⑩ Sample No.
⑪ Date and time of the measurement
⑫ Data No. of the color difference target data used for the measurement
⑬ UV setting used for the measurement
⑭ Measurement area used for the measurement
⑮ Sample data (Use ◀ or ▶ to switch tabs)
⑯ An exclamation mark (
!
measurement is performed even though a light intensity decrease warning or measurement out-of-range
warning has occurred.
① ②③ ④
⑦
⑩
⑪
⑫
) will be displayed for measurements that are beyond the guaranteed range or when
⑤ ⑥
⑧
⑨
⑮
⑬ ⑭ ⑯
2
40