Installing The Target Mask - Konica Minolta CM-36dGV Instruction Manual

Installing the Target Mask

With this instrument, the target mask can be selected according to the specimen being measured and application.
Target masks: LAV CM-A291 (measurement area Ø25.4 mm / illumination area Ø30 mm)
LMAV CM-A292 (measurement area Ø16 mm / illumination area Ø20 mm)
MAV CM-A293 (measurement area Ø8 mm / illumination area Ø11 mm)
SAV CM-A294 (measurement area Ø4 mm / illumination area Ø7 mm)
Procedure
1 Push the sample holder down and hold it so it is opened.
Memo • Turning the sample holder to the right while it is at its lowest
position will hold it so it remains open.
2 Pull the currently installed target mask down to remove
it.
Memo
• The target mask is fastened by a magnet.
• There are notches on the left and right of the instrument contact
surface. Placing your hand so that your thumb and index finger
are positioned on the notches will make it easier to remove.
3 Orient so that the instrument target mask mark ( ) is
facing toward you, and install the target mask so that
the outer periphery fits onto the indentation of the
integrating sphere.
Memo
• Install the target mask with the black painted surface on the
inside (CM-36dGV side).
Notes
• If the installation direction of the target mask is not correct,
it will not fit properly in place. Check the direction and
fit the target mask in place, then check that there is no
looseness or lifting.
4 Return the sample holder to its original position.
Precautions for Use of the Target Mask
• Do not scratch the target mask inner surface (black coated surface), or allow it to be dirtied by fingerprints or
other dirt.
• The target mask may become discolored if left in a place that is exposed to light. Therefore store the target mask
in the accessory case (CM-A286) when it is not in use.
• Do not leave the instrument with the target mask installed for a prolonged period. The target mask may become
stuck to the sample holder.
20