Setting Network Settings For Connecting Fd-9 To Computer Via A Lan; Setting Network Settings Directly - Konica Minolta FD-9 Instruction Manual

Connecting FD-9 to Computer

Setting Network Settings for Connecting FD-9 to Computer via a LAN

❙ ❙
The FD-9 can be connected to a LAN and shared by multiple computers. When connecting the FD-9 to a LAN, network settings can be
performed directly or DHCP (Dynamic Host Configuration Protocol) can be used.
• Network settings can also be performed from Measurement Utility Software FD-S2w when the FD-9 is connected via USB.

Setting network settings directly

The IP address, subnet mask, and default gateway can be set directly in the settings screen.
• It is not possible to set the network name directly using the FD-9 buttons.
1
Press to open the settings screen.
2
Press or
The first number of the IP address will be highlighted.
• "IP address" will be disabled if "DHCP" is set to "ON". To change the setting to "OFF", see p. 22.
3
Press or
number.
• Holding or
• Values between 0 and 255 can be set. If
has been reached, the number will change to the highest or lowest value.
4
Press to move to the next number.
5
Repeat steps 3 and 4 until all numbers have been set for the IP
address.
6
Press to select "Subnet mask" and press
the subnet mask will be highlighted.
7
Press or
number.
• Holding or
• Values between 0 and 255 can be set. If
has been reached, the number will change to the highest or lowest value.
8
Press to move to the next number.
9
Repeat steps 3 and 4 until all numbers have been set for the subnet
mask.
20
repeatedly to select "IP address" and press
repeatedly to set the desired value for the first
pressed will cause the value to change continually.
or is pressed again when the lowest or highest value
repeatedly to set the desired value for the first
pressed will cause the value to change continually.
or is pressed again when the lowest or highest value
.
. The first number of