User Constant Structure And Three Access Levels; Access Levels For User Constants; Access Level Structure - YASKAWA VARISPEED-616G5 Instruction Manual

Introduction
1.1.3 Functions
1
MENU

User Constant Structure and Three Access Levels

J
The VS-616G5 has a number of user constants for setting various functions. These user constants are clas-
sified into a hierarchy to make them easier to use.
The levels are as follows from top to bottom: Modes, Groups, Functions, and Constants. The access levels
for the user constants are shown in Table 1.3.
Table 1.3

Access Levels for User Constants

Level
Mode
Groups
Functions
Constants
The VS-616G5 allows the following three access levels to be set in order to further simplify setting user
constants. (An access level is a range of user constants that can be referenced or set.)
Quick-Start
Basic
Advanced
In general, press the DATA/ENTER Key to move from an upper to a lower level. This varies somewhat,
however, according to the access level, as shown in Fig. 1.1. For the Quick-Start access level, which has
few user constants that can be set, pressing the DATA/ENTER Key jumps directly to the user constant lev-
el; whereas for the Advanced access level, which has many user constants, pressing the DATA/ENTER
Key first leads to the Group level.
Operation mode
Initialize mode
Programming mode
Displays group level.
[Mode]
Fig 1.1

Access Level Structure

Classified according to operation
Operation: For operating the Inverter. (All kinds of monitoring are possible.)
Initialize: For selecting the language displayed at the Digital Operator, set-
ting access levels, initialization, and the control modes.
Programming: For setting user constants for operation.
Autotuning: For automatic calculation or setting motor constants. (Only under
the vector control mode.)
Modified constants: For referencing or changing user constants after shipping.
Classified by application.
Classified by function. (See user constants.)
Individual user constant settings.
Reads/sets user constants required for trial operation. [Factory setting]
Reads/sets user constants that are commonly used.
Reads/sets all the user constants that can be used.
[Advanced]
Displays function level.
Application
Tuning
Reference
[Groups]
1 - 6
Contents
DATA
ENTER
[Quick-Start]
[Basic]
Displays constant level.
b1 Sequence b1-01 Reference source
b1-02 Run source
b1-03 Stopping method
Constant to be changed
C1 Accel/Decel C1-01 Accel Time 1
C2 S-curve Acc/Dec C1-02 Decel Time 1
[Functions] [Constants]