Step
Key Sequence
16
The access level has been set to the user program access level.
Figure 4.10 shows the structure of the user constants.
MENU
Fig
4.10
4.2.6 Programming Mode
The Inverter user constants can be set in programming mode. The user constants which can be changed
and displayed depend on the access level and control method that are being used. Refer to the following
table to determine if a user constant can be changed.
The groups of constants in programming mode and their functions are shown in Table 4.5.
Digital Operator Display
Access Level
User Program
G5: Main Menu :
ESC
Initialize
Operation mode
Initialize mode
Language
Programming mode
Access Level
Control Method
Initialize
Password
Function Selection A2
These user constants can be changed and displayed only in
the Advanced access level.
Structure of User Constants
4 - 25
4.2 Modes
Remarks
After a few seconds, the Operator dis-
play is as shown on the left.
A2-01 User Param 1
A2-02 User Param 2
A2-32 User Param 32
4