Table E-M. Port Administration, Trunks (Menu=1 - AT&T Network Adapter 25 Installation And Maintenance Manual

APPENDIX E: Administration Codes and Data
Table E-M.
ACTION
0 Physical port number
1 Enter trunk port type code
2 Enter trunk number
3 Assign class-of-service code
4 Assign pooled facility access code.
5 Allow dial access
6 Assign the trunk to a DGC group
7 Make this a directed night service trunk
Assign night service delay announcement
8
9 Type of signaling on incoming calls
(Tie-Trunks only)
10 Determine pooled trunk hunting order of a
specified trunk {Read Only}
11 For Switched Loop Attendant systems ONLY:
Priority of trunk to ring in queue†
Note: The TN747B CO Trunk port can be administered as either Ioop-start or ground-
start, but not both at the same time. If a TN747B is administered before it is installed in
a slot, the System 25 must be warm started before it will recognize the TN747B.
Not administrable for trunk port type codes 901-902 or 1003-1008.
†
Not administrable for trunk port type codes 901-902 or 1001-1008.
*
E-26
Port Administration, Trunks (Menu=1)
DESCRIPTION
DATA
CSSPP
[See Table E-N]
[0001 -9999;
0001-0104]
[(DID–1-4; 3)
(All other—
See Table E-O; 8)]
[Facility access code;
(100,101,102)
O if trunk not in
any group]
[l=Y/0=N]
[1-32; 0 or none]
[1 Y/0=N]
[1 for first
announcement,
2 for second
announcement,
O for none]
[1=Tone/0=Pulse]
[0-7; 0=won't ring
in queue/or
1=highest priority,
thru 7=lowest
priority]