AT&T Network Adapter 25 Installation And Maintenance Manual page 352

PORTS, Station/Trunk/Special Port Circuit Board Options
FOR QUALIFIED SYSTEMS TECHNICIANS ONLY
(See Table E-S, " Applicable Options " )
ACTION
32 Set CO disconnect time (in 20 msec
increments)
33 Set end-to-end signaling tone timing
(in 20 msec increments)
FOR TN742 AND ZTN78 ONLY:
FOR ALL OTHER BOARDS:
34 Set end-to-end signaling pause timing
(in 20 msec increments)
FOR TN742 AND ZTN78 ONLY:
FOR ALL OTHER BOARDS:
Set hybrid balance. Data is balance
35
t y p e :
0=Resistor/Capacitor.
default to 0; station ports default to 1.
36 Set gain; 1 (Gain=3dB) or 0 (Gain=0dB)
37 Set E&M signaling type. Data is
signaling type 0 (Type 1 compatible), 1
(Type V), or 2 (Type l).
Set answer supervision delay timing
38
Warning: The default values in Tables E-R and E-S must not be
changed without the support and guidance of Tier Ill
s t a f f .
APPENDIX E: Administration Codes and Data
Table E-R. Port Options
DESCRIPTION
1=Resistor;
Trunk ports
DATA
[0-2540 msec; 500]
[20-2540 msec; 340]
[0-2540 msec; 60]
[20-2540 msec; 100]
[0-2540 msec; 60]
[1/0] .
[ 1 / 0 ]
[ 0 - 2 ]
[0-51 00 msec; 300]
E-33