AT&T Network Adapter 25 Installation And Maintenance Manual page 357

APPENDIX E: Administration Codes and Data
Table E-V. System Administration (Menu=4) (Contd)
ACTION
Change administration password (up to 8 ["8 characters or less"]
75
printable characters, no spaces allowed,
display always shows "?????????")
Change display ID for "PDC 0" (up to 11
76
printable ASCII characters
Change/remove
77
unassigned DID numbers (up to 11
printable ASCII characters
Change/remove
78
unassigned DID numbers (up to 11 or ** to remove; "NO
printable ASCII characters)
81 Switched Loop Attendant system; Audible
tone at expiration of hold timer?
Switched Loop Attendant system: Length
83
of hold timer (seconds)
switched Loop Attendant system: DID
84
access code to receive "0" treatment (PD.
format, no leading zeros, can't exist in
system number plan prior to this)
Switched Loop Attendant system; Enable
85
automatic hold feature?
86 Switched Loop attendant system: Should
calls return to the common queue after
second hold timer expires?
Single-position Switched Loop Attendant
87
system: PD. of multiline station serving
as coverage when the attendant is in
POS BUSY mode (PD./station must
already exist)
For Switched Loop Attendant System
88
ONLY: Specify SLAC attendant (1st or
2nd) for Action 89, below.
E-38
DESCRIPTlON
display ID
display ID
DATA
["ATTENDANT']
for ["11 characters or less,"
or ** to remove;
"OUTSIDE"]
for ["11 characters or less,"
DID,IN"]
[1=Y/0=N]
[1 O-255; 20]
[PD.]
[ 1 = Y / 0 = N ]
[ 1 = Y / 0 = N ]
[ P D . ]
[1=1st Att.,
2=2nd Att.]
November 1995