AT&T Network Adapter 25 Installation And Maintenance Manual page 219

ERROR MESSAGE
AND DESCRIPTION
Received Incorrect Number of
This error indicates
DID Digits:
that the CO is set up to send a
number of DID digits different
from what the switch has been
administered to receive.
Service Circuit or
RIMS Insane:
Tone Detector CP problem.
RIMS Sane: RIMS recovered from Recoverable; no action required.
an insane condition.
ROM Checksum
CPU/Memory CP ROM checksum
test has failed.
Ringing Without Ground:
was not detected from CO within
5 seconds from the time ringing
starts.
Service Circuit In Mismatched
slot: Service Circuit in slot
translated for other type CP; two
Circuits mounted i n
Service
cabinet. Only one Service Circuit
(ZTN85 or ZTN131 [R3]) allowed
p e r system. Additional tone
detection available using Tone
Detector CP (TN748).
POSSIBLE SOLUTION
Ensure that trunks are properly
translated.
verify the correct number of digits
to be sent. Test trunk per Figure
4 - 3 .
If an "RIMS Sane" occurred, the
system will remove this error from
the permanent alarm table. If the
problem
replace the faulty CP.
Failure: If the problem persists, check or
replace the CPU/Memory CP.
Ground Check Tip/Ring for possible
reversal.
Ensure that only one ZTN85 or
ZTN131 (R3) is in the system. If
there are others, remove them.
Also make sure that the ZTN85 or
ZTN131 (R3) is in it's translated
slot.
MAINTENANCE
Notify local CO to
persists, check or
4-43