Scheduled Maintenance; Fuser Maintenance Kits - Lexmark M5150 Service Manual

Scheduled maintenance

The operator panel displays the message 80 or Scheduled Maintenance when it reaches certain page counts. It is
necessary to replace the appropriate maintenance kit at certain intervals to maintain the print quality and reliability of
the printer. If needed, reset the maintenance counter after performing scheduled maintenance.

Fuser maintenance kits

The printer may stop printing when the fuser rated life is reached. At rated fuser life, a Fuser maintenance kit is required.
The correct Fuser maintenance kit must be installed for the type of fuser that is installed in the printer. See
the type of fuser used in the printer" on page
Code levels prior to Base code of LW20.DN4.P231-0 and Engine code of FDN.DN.E410-0 set the 80.3x error as a
non‑continuable stop. To change the 80.3x error code to a continuable stop, please see technical bulletin TE523 by
visiting www.lexmark.com. A continuable stop is an error code that will allow the user to continue using the printer
once the error is acknowledged using the control panel.
There are multiple warnings to indicate that the fuser is nearing end of life and that a maintenance kit is required.
Maintenance kit nearly low [80.0x]
1
Replace the maintenance kit. For more information, see the instruction sheet that came with the replacement parts.
2
From the printer control panel, select Continue to clear the message and continue printing. For non‑touch‑screen
printer models, press
3
If you do not have a maintenance kit, then see
Ordering a maintenance kit section of the User's Guide, or visit www.lexmark.com.
Maintenance kit low [80.1x]
1
Replace the maintenance kit. For more information, see the instruction sheet that came with the replacement parts.
2
From the printer control panel, select Continue to clear the message and continue printing. For non‑touch‑screen
printer models, press
3
If you do not have a maintenance kit, then see
Ordering a maintenance kit section of the User's Guide, or visit www.lexmark.com.
Maintenance kit very low, 2000 estimated pages remain [80.2x]
1
Replace the maintenance kit. For more information, see the instruction sheet that came with the replacement parts.
2
From the printer control panel, select Continue to clear the message and continue printing. For non‑touch‑screen
printer models, press
3
If you do not have a maintenance kit, then see
Ordering a maintenance kit section of the User's Guide, or visit www.lexmark.com.
795.
to confirm.
"Replacing fuser maintenance kits" on page
to confirm.
"Replacing fuser maintenance kits" on page
to confirm.
"Replacing fuser maintenance kits" on page
Maintenance
793
4063
"Identifying
794, or see the
794, or see the
794, or see the