Front-Pluggable Mics; Fixed (Built-In) Mics; Built-In 10-Gigabit Ethernet Mic - Juniper MX10 Hardware Manual

MX5, MX10, MX40, and MX80 3D Universal Edge Router Hardware Guide

Front-Pluggable MICs

Fixed (Built-in) MICs

24
You can install and remove MICs in the MX5, MX10, MX40, and modular MX80 chassis.
The MIC slots are labeled 1/MIC 0
above the MIC slot.
You can install MICs of different media types as long as the router supports those MICs.
For complete specifications, see

Built-in 10-Gigabit Ethernet MIC

The built-in 10-Gigabit Ethernet MIC is fixed on the MX5, MX10, MX40, and MX80 routers.
The MIC is labeled 0/MIC 0
Ethernet MIC has the following components:
Hardware features:
Four 10-Gigabit Ethernet ports labeled
High-performance throughput on each port at speeds up to 10 Gbps
Line-rate on all four 10-Gigabit Ethernet ports
LAN-PHY mode at 10.3125 Gbps
WAN-PHY mode at 9.953 Gbps
Maximum transmission units (MTUs) of up to 9192 bytes
Link LED, one green per port. For more information, see
on page 16.
Software features:
Configurable LAN-PHY and WAN-PHY mode options
Synchronous Ethernet support
Optical diagnostics and related alarms
Virtual Router Redundancy Protocol (VRRP) support
IEEE 802.1Q virtual LANs (VLANs) support
Remote monitoring (RMON) EtherStats
Source MAC learning
MAC accounting and policing—Dynamic local address learning of source MAC addresses
Flexible Ethernet encapsulation
Multiple tag protocol identifiers (TPID)
Cables and connectors:
Duplex LC/PC connector (Rx and Tx)
and 1/MIC 1 . Each MIC slot has an ejector handle located
"MICs Supported by MX Series Routers" on page
and is located on the front panel. The built-in 10-Gigabit
0 through 3 , left to right.
"Link LEDs on the Front Panel"
Copyright © 2017, Juniper Networks, Inc.
26.