Avaya XT Series Deployment Manual page 61

2. Remove the camera stabilizing cartons before connecting the camera to avoid damage to
the system.
3. Insert the following connectors on the camera cable to the ports on the back of the camera,
as shown in
• The DVI connector to the DVI socket
• The 8-pin connector to the IN (RS232C) socket
• The power connector to the DC IN 12V socket
4. With the camera turned off, set the System Select switch on back of the camera to 7 using
a slotted 2.5 mm screwdriver
page 61).
This is only for Premium, Advanced, and Standard II cameras.
5. Insert the two connectors on the other end of the camera cable to the ports on the XT
Codec Unit
• Connect the HDMI plug to the vertical socket.
• Connect the other plug (power) to the horizontal socket.
We recommend keeping the DVI socket available for a computer connection (for example,
to share content in a videoconference).
August 2020
Figure 26: Connecting cables to the back of the camera
Figure 26: Connecting cables to the back of the camera
(Figure 26: Connecting cables to the back of the camera
(Figure 27: Connecting the camera cables to the XT Codec Unit
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
Connecting Cameras or DVD players
on page 61:
on page 62).
on
61