Avaya XT Series Deployment Manual page 198

Advanced Configuration of the XT Series
Procedure
1. Access the AT settings. From the XT Series web interface, select Administrator
Settings > Utilities > Remote Access > AT Commands. From the endpoint's main menu,
select Configure > Advanced > Utilities > Remote Access > AT Commands.
2. Set the fields as required.
Table 51: Configuring AT command settings
Field Name
AT commands
management
Enable all addresses
Address
August 2020
Figure 96: AT Commands
Description
Select Yes to enable remote control AT commands API via both
TCP and serial cable. Select IP only to restrict it to a TCP
connection only, or RS232 serial port only to restrict AT control to
an RS232 serial cable connected to the USB port on the XT
Series.
Select No to disable remote control AT commands API via both
TCP and serial cable. If your deployment includes Avaya Meetings
Management, disabling this feature results in a failure to manage
the XT system.
Select No to restrict AT remote access via TCP to specific devices
with an IP address in the range of the Address and Subnet Mask
fields below.
Enter a single IP address or the first address in the subnet that is
allowed to remotely control the unit with AT commands.
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
Table continues...
198