Avaya XT Series Deployment Manual page 71

• Attach one end of the VISCA control cable to the IN RS-232C connector on the
second camera.
• Attach the other end to the OUT RS-232C connector on the previous camera.
b. Connect the DVI-HDMI cable:
• Attach the DVI connector to the DVI socket on the second camera.
• Attach the HDMI connector to the HDMI socket labeled 2 for the XT5000 and to the
socket labeled 1 for the XT7000 on the Avaya XT Series Camera Switch.
6. If required, repeat the above step for a additional HDMI devices.
7. Check that the SYSTEM SELECT switch on the back panel of each camera is set to 7:
This is only for Premium, Advanced, and Standard II cameras.
Caution:
To adjust the switch, you must first turn the camera off. Adjust it using a slotted 2.5 mm
screwdriver.
8. Turn on the XT Codec Unit by pressing the
This also turns on the Avaya XT Series Camera Switch.
9. Connect one end of the power supply cable to the DC IN 12V connector on each camera,
and the other end into one of the power sockets on the wall.
August 2020
Second Camera
XT Camera Switch
Connected to XT5000
XT Camera Switch
Connected to XT7000
Figure 36: Connecting the second camera
Figure 37: Checking the SYSTEM SELECT switch
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
Connecting Cameras or DVD players
First Camera
power key on the XT Remote Control Unit.
71