Configuring Wrap-Around Navigation - Avaya XT Series Deployment Manual

Advanced Configuration of the XT Series
Procedure
1. Access the MCU settings. From the XT Series web interface, select Administrator
Settings > Calls > Preferences > MCU. From the endpoint's main menu, select
Configure > Advanced > Calls > Preferences > MCU.
2. For the Default Lecturer Layout, choose from the following options:
• Select 1 terminal to enable enhanced lecture mode. In enhanced lecture mode, the XT
Series hosting the meeting sends the local participant video as the lecturer, while the
lecturer can see the Continuous Presence (CP) of other participants. This is the default
behavior.
• Select 2 terminals — A to send everyone, including the lecturer, the lecturer video as a
large display and the video of the previous/active speaker as a small display.
3. From the web interface only, select Save.

Configuring Wrap-around Navigation

About this task
You can configure the XT Series to enable users to cycle among available menu items in some
user interface panels using the arrows. The selection restarts from the farthest item in the same
direction, if no other items are available.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
August 2020
Figure 91: MCU Preferences
on page 151.
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
192