Avaya XT Series Deployment Manual page 123

Table 20: Configuring general monitor settings
Field Description
Name
Number of
Activate the HDMI ports on the XT Codec Unit which connect to a monitor: the HD1
monitors
and/or the HD2
connect it to the HD1 port on the back panel. This monitor is only supported on the Avaya XT7000
Series and is only supported as the main monitor.
• <auto > indicates the system automatically detects the number of connected monitors
(recommended).
• HD1/HD2 forces the unit to accept input only from a single monitor connected to either HD1
or HD2
connected to a remote system, unless you select Duplicate to HD2.
• HD1 (Menu & Video Rx) + HD2 (Present) uses both monitor connections, where the main
monitor displays system menus and remote video, while shared content is on the auxiliary
monitor. This is the default mode with two connected monitors set to <auto > .
• HD1 (Menu & Present) + HD2 (Video Rx) uses both monitor connections, with system menus
and PC content on the main monitor, while remote video is on the auxiliary monitor.
• HD1 (Present) + HD2 (Menu & Video Rx) uses both monitor connections, with system menus
and remote video on the auxiliary monitor, while shared content is on the main monitor.
August 2020
port. If you are using a 4K UHD or 2160p (3840x2160) monitor, you must
Figure 56: Dual monitor video layouts with presentation
. If you connect a second monitor it would appear blank when the end point is
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
Configuring Monitors
port
Table continues...
123