Avaya XT Series Deployment Manual page 188

Advanced Configuration of the XT Series
You can also recall presets for remote cameras if they support FECC. Far End Camera Control
(FECC) is a feature of endpoint cameras, where the camera can be controlled remotely by another
endpoint in the call.
Procedure
1. To recall a position and move the camera quickly to a preset:
• From the new XT Remote Control Unit, press and hold the position number.
• From the previous XT Remote Control Unit, press Select then enter the position
number, up to two digits. * indicates 10, # indicates 11.
• From the XT Series web interface, select More Actions located just under the tabs,
then select Control Camera, and press Select on the row of the position number.
2. To save the camera to a new position, first move the camera and set its zoom.
• From the endpoint's main menu, select Control Camera (or from the In-Call menu,
during a call), and use the arrow and zoom keys to position the camera.
• From the XT Series web interface, select More Actions located just under the tabs,
then select Control Camera, and select the arrows and zoom icons to position the
camera.
To position a remote camera with the XT Remote Control Unit, press near/far. To switch to
a different local camera, press ok/menu and select Video Source.
3. To store a new preset position:
• From the new XT Remote Control Unit, press ok/menu and select Presets, then press
the new position number (0-9).
• From the previous version of the XT Remote Control Unit, press the Presets > Memo
key, then press the new position number (0-99). To save positions 100-109, press * then
0-9. For 110-119, press # then 0-9.
August 2020
Figure 86: Recalling a camera preset with XT Remote Control Unit
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
188