Table of Contents
Advertisement
Network Status
Figure 9: Network Status screen
Tool Status
Figure 10: Tool Status - Good Signal
Figure 13: Tool Status - Last Signal
Good
Soft keys
1. Signal – Show the signal strength of each tool.
2. Address – Show the address of each tool
3. No function
4. Exit [ESC] – Returns to the Unit Status screen.
The Tool Status screen shows the status of the tools learned into the unit. This screen shows the
signal strength of the last packet from the tool but can also show the radio address of the tools.
EYFR03 User Manual
Chapter 1: Overview
The network status screen shows the current Ethernet
status of the unit. The MAC address is assigned by the
factory and cannot be changed. The IP address, subnet
mask, and gateway may be edited from the Network
Settings - General screen or assigned via DHCP.
The Ethernet 1 and 2 lines indicate if a physical cable
connection is detected on the corresponding Ethernet
ports of the unit. If no connection on a port is detected,
the unit will show "Not connected". If a connection is
detected, the baud rate and duplex of the connection will
be listed.
Figure 11: Tool Status – Low Signal
19 of 110
Figure 12: Tool Status - Bad Signal
20 January 2020
v1.6.0
Advertisement
Table of Contents
