Panasonic EYFR03 User Manual page 103

3.5 bit Batch Decrement
4 25 VIN
29 1 Reserved
30 1 Temp Tool
Number
31 1 Temp Socket
32 1 Temp Batch
33 1 Temp Lock on
Batch
34 1 Temp Cross
Thread Reduction
35 1 Temp Buzzer
Setting
36 1 Temp
Crossthread/Rehit
Detection
37 1 Temp Variable
Speed Control
38 1 Temp Flush
Detection Mode
39 1 Temp Torque
Setting
40 1 Temp LED Light
41 1 Temp Flush
Detection Delay
42 1 Temp
Retightening
Prevention
43 1 Temp Socket
Extension Mode
44 2 Temp Time
Between Cycles
46 2 Temp Time
Between Batches
EYFR03 User Manual
Chapter 10: PROFINET
BOOL When this value changes from false to true, the EYFR03 will
decrement the batch count.
Ignored if the count is 0.
CHAR[25] Sets the VIN to be used by the controller.
USINT Padding byte to align structure. This field does not need to be
listed in the PLC data type.
Temporary Parameter Settings
USINT Tool number used for temporary parameter
USINT
USINT
BOOL
AccuPulse Tool Settings
USINT Controls if the tool uses its cross-thread reduction behavior
0 – Off
1 – >360° Reverse
USINT Controls when the buzzer in the tool sounds
0 – Off
1 – OK
2 – NOK
USINT If the clutch is activated before the minimum runtime set by
this setting, the tool alerts the operator to a NOK fastening.
Specified in tenths of a second (range 0-3.0s)
USINT Controls if the tool run speed can be controlled by use of the
trigger
0 – Variable
1 – Fixed
USINT Set to 1 for applications with light load before snug point. Set
to 7 for applications with heavy loads or varying joint rate
before snug point. (range 1-7)
USINT Controls the torque setting of the tool. (range 0-40)
USINT Controls how the LED on the tool is activated
1 – Remote
2 – Trigger
USINT Delays Flush Torque Detection mode and ignores loads for the
specified time.
Specified in seconds (range 0-30s)
USINT Controls the amount of time the tool is prevented from
operating after shut-off.
Specified in tenths of a second (range 0-3.0s)
USINT Specifies the socket extension in use.
0 – None
1 – 150mm
2 – 250mm
OK/NOK Tool Settings
UINT Amount of time after an accepted tightening before another
tightening should be accepted.
Specified in seconds (range 0-9999s)
UINT Amount of time after a batch completion before another
tightening should be accepted.
Specified in seconds (range 0-9999s)
103 of 110 v1.6.0
20 January 2020