Panasonic EYFR03 User Manual page 33

In standard mode, all parameters in the group must complete their batches before any parameter
can start a second batch. When a parameter completes, the tool used by that parameter will be
disabled. When the whole group is completed and Lock on done is set to No, all tools used by
parameters in the group will be enabled to run the group again.
Standard mode is intended for applications where multiple parameters must all be run the same
number of times. For example, a standard group could be used at a station with two operators
that need to attach the left and right brakes to a vehicle. In this case, each vehicle must have both
brakes attached, but there is no reason one must be attached before the other. However, each
vehicle should have both brakes attached before the next vehicle is started.
In free run mode, parameters in the group can run independently. When a parameter completes,
it restarts immediately and may perform additional tightenings. In this mode, the Lock on done
and Batch beep on settings are ignored.
Free run mode is intended for applications where the qualifier simply needs to report the
tightenings from multiple tools but does not need to synchronize how much one tool runs
compared to another.
Group Parameter Selection
Figure 30: Group Parameter Select screen
Soft keys
1. 1-8 – Shows parameters slots 1-8 of the group
2. 9-16 – Shows parameter slots 9-16 of the group
3. No function
4. Exit [ESC] –Returns to the Group Edit screen
Changes made on this screen are saved or discarded when exiting the Group Edit screen.
Parameter column
In the parameter column, you may select the parameters for the group by typing the number of
the desired parameter in each row. The order on this screen determines the order they are shown
on the Run screen but is otherwise not important.
Batch column
In the batch column, you may enter the batch size for the parameter when running it as part of
the group. When a parameter is selected, this column will be filled with the batch currently
defined in the parameter itself. Changing values in this column only affect the parameter while it
EYFR03 User Manual 33 of 110 v1.6.0
Chapter 3: Configuring the unit 20 January 2020