Table of Contents
Advertisement
Tool Inputs
Tool #X Accept
Inputs used: 1 per tool
This input is used to define an input tool within the EYFR03, which can be inserted into a
parameter to allow the EYFR03 to monitor the operation of an external device.
Tool #X Reject
Inputs used: 1 per tool
This input is used along with a Tool X Accept input to define an input tool within the EYFR03.
The reject input is not required, but can be used if the external device reports reject conditions
that should be monitored.
Binary selection of operations
The binary selection inputs, Select Parameter (binary), Select Group (binary), Select Job
(binary), and Select Item, allow you to select the number of inputs to use. The more inputs that
are used, the more items you can select.
The number of selectable items is also the maximum item number selectable for the number of
inputs. For example, with 3 inputs, you can only select parameters 1-7, not any combination of 7
parameters.
Outputs
The outputs of the EYFR03 qualifier are 24VDC relays that can provide a total of 2A across all
outputs. The discrete I/O has a single common pin for the high side of all relays and a signal pin
for each output. The outputs can be used to report the status of the qualifier.
Parameter #X Active
Inputs used: 1 per parameter
This output indicates when a parameter is active, either because it was selected directly or as part
of a group or job. One copy of this field exists for each of the 100 available parameters. The
output will remain active while the unit is suspended if the associated parameter is selected.
Group #X Active
Inputs used: 1 per group
EYFR03 User Manual
Chapter 5: Discrete I/O
Number of Inputs
Number of Selectable Items
1
1
2
3
3
7
4
15
5
31
6
63
7
100
63 of 110
v1.6.0
20 January 2020
Advertisement
Table of Contents
