Panasonic EYFR03 User Manual page 65

Tool #X Active
Inputs used: 1 per tool
This output indicates when a tool is active. A tool is active whenever a parameter that uses it is
active, either because the parameter was selected directly or as part of a group or job. One copy
of this output exists for each of the 16 available tools. The output will remain active while the
unit is suspended if the associated tool was in use at the time of suspend.
Qualifier Suspended
Inputs used: 1
This output indicates if the qualifier is currently suspended.
Tool #X Cycle Accept
Inputs used: 1 per tool
This output will be activated every time the tool performs an accepted tightening. This output
will also trigger for the last cycle in a batch.
This output is a momentary output. The duration this output will be active is determined by the
Cycle Timeout qualifier setting. If the Cycle Timeout is set to 0, this output will behave as a
latching output and will remain active until another tightening is performed by the tool or the
parameter using the tool is stopped.
Tool #X Cycle Reject
Inputs used: 1 per tool
This output will be activated every time the tool performs a rejected tightening.
This output is a momentary output. The duration this output will be active is determined by the
Reject Timeout qualifier setting. If the Reject Timeout is set to 0, this output will behave as a
latching output and will remain active until another tightening is performed by the tool or the
parameter using the tool is stopped.
Tool #X Batch
Inputs used: 1 per tool
This output will be activated every time the tool completes a batch.
This output is a momentary output. The duration this output will be active is determined by the
Batch Timeout qualifier setting. If the Batch Timeout is set to 0, this output will behave as a
latching output and will remain active until another tightening is performed by the tool or the
parameter using the tool is stopped.
Operation Complete
Inputs used: 1
This output will be activated every time an operation completes.
EYFR03 User Manual 65 of 110 v1.6.0
Chapter 5: Discrete I/O 20 January 2020