Panasonic EYFR03 User Manual page 41

1. Unit will only beep if Beep on reject is set to Yes and Volume is not 0.
2. Overall bad will be indicated by shading the operation name on the top row of the Run screen
yellow and will show yellow instead of blue in the parameter area when the parameter batch
is completed.
All results from tools that are not currently running are ignored, regardless of this setting.
Batch Reset button
Default: Show
Values: Show, Hide
This setting determines if the Batch Reset button is available on the Run screen.
Serial printer format
Default: None
Values: None, Line, CSV
This setting determines the format used for serial printing of tightenings.
Bypass Verify Inputs
Default: no
This setting determines if the Verify Tool and Verify Socket inputs are ignored. See the Discrete
I/O section of the manual for more information about the inputs.
Startup Operation
Default: Last
Values: Last, None
This setting determines what operation will be run on unit startup. If set to Last, the last running
operation when the unit turned off will be restarted at the beginning of the operation when the
unit turns on. If set to None, the unit will be in the No active parameter state on startup.
Tool On Time
Default: 90 minutes
Values: 20 to 720 minutes
This setting determines how long an AccuPulse tool stays on without use before it sleeps.
OK/NOK tools are not affected by this setting.
EYFR03 User Manual
Chapter 3: Configuring the unit
41 of 110 v1.6.0
20 January 2020