Panasonic EYFR03 User Manual page 29

This setting determines if the unit will lock or restart the parameter when a batch is completed.
When set to Yes, the qualifier will not restart the parameter when a batch is completed and will
require a batch reset or parameter selection command to restart the parameter. When set to No,
the qualifier will restart the parameter when a batch is completed.
This setting is ignored when running the parameter as part of a group or job.
OK/NOK Fields
Time between cycles
Default: 0
Range: 0 to 9999 seconds
This setting controls the minimum amount of time after an accepted tightening before another
tightening should be accepted. Any additional tightenings performed within this time after an
accepted tightening will be automatically considered a reject.
Time between batches
Default: 0
Range: 0 to 9999 seconds
This setting controls the minimum amount of time after a batch completion before another
tightening should be accepted. Any additional tightenings performed within this time after a
batch completion will be automatically considered a reject.
AccuPulse Fields
Torque setting
Default: 1
Range: 1 to 40
This setting controls the torque setting of the tool.
Flush detection mode
Default: 1
Range: 1 to 7
Set to 1 for applications with light load before snug point. Set to 7 for applications with heavy
loads or varying joint rate before snug point.
Buzzer setting
Default: Off
Range: Off, OK, NOK
This setting controls the when the buzzer in the tool sounds.
EYFR03 User Manual 29 of 110 v1.6.0
Chapter 3: Configuring the unit 20 January 2020