Panasonic EYFR03 User Manual page 54

Selection Modes
The EYFR03 will use one of several modes to determine how it uses the VIN to make selections:
None
No selections are made based on barcode scans. The VIN length setting will still be used to
validate VIN scans, but the EYFR03 will not select an operation based on the scan. If you want
to keep the defined list of selections, but temporarily not use them, put the EYFR03 in this mode.
Single Scan
All scans are treated as both VINs and selectors. The selector length setting is not used in this
mode, and only scans matching the VIN length will be processed. The EYFR03 will check each
scan against its selection list for a match and start the appropriate operation if a match is found.
Dual Scan
Scans are treated as either VINs or selectors based on their length. The VIN and selector lengths
must be different to use this mode. The VIN length or selector length may be variable, but not
both. Any scan that matches the VIN length (or does not match the selector length, if the VIN is
variable length) will be put in the VIN field but will not cause the EYFR03 to select an
operation. The EYFR03 will check any scan that matches the selector length (or does not match
the VIN length, if the selector is variable length) against its selection list for a match and start the
appropriate operation if a match is found.
Selector then VIN
The EYFR03 will require a selector scan first followed by a VIN scan. In this mode, the VIN
and selector lengths may be the same or different. While the EYFR03 is waiting for the first
scan, it will ignore any scans that do not match the selector length. Once a valid length scan is
found, the EYFR03 will process it as a selector, checking it against the selection list for a match
but not immediately starting the matching operation. If the scan is a match or the No match
behavior is Continue, the EYFR03 will start waiting for a VIN scan. Once a valid length scan is
found, the EYFR03 will start the matching operation from the selector scan.
VIN then Selector
The EYFR03 will require a VIN scan first followed by a selector scan. In this mode, the VIN
and selector lengths may be the same or different. While the EYFR03 is waiting for the first
scan, it will ignore any scans that do not match the VIN length. Once a valid length scan is
found, the EYFR03 will store it as the VIN and start waiting for a selector scan. Once a valid
length selector scan is found, the EYFR03 will process it as a selector, checking it against the
selection list for a match and starting the matching operation if a match is found.
EYFR03 User Manual 54 of 110 v1.6.0
Chapter 4: 20 January 2020