To Load The Document Feeder; Using The Multifunction Finisher (Mff); How To Select The Mff Finishing Type As The Output Device - Xerox Nuvera User Manual

How Do I...

To load the Document Feeder

Note
To ensure all image information from a 12 x 18 inch original is captured, use the Document Glass.
Note
Follow the steps below to avoid misfeeds and/or skewed output. The document feeder side guides must
be positioned correctly to avoid misaligned copies or scans.
1. Remove any staples, paper clips, etc. that may be binding the paper set.
2. Move the side guides outward as far as they will go.
3. Place the document set to be scanned or copied face up in the center of the document feeder input
tray. Make sure the document set is neatly stacked to avoid skewing.
For more information on paper loading (type and feed direction), see Document Feeder & Scanner
Specifications.
4. Move the side guides inward. Make sure the paper guides are touching both sides of the paper stack.
Failure to do so may result in sheets skewing and skewed images on copies or scans.
5. Make any programming choices in the user interface.
6. Click Start.
If a jam occurs in the Document Feeder, see

Using the Multifunction Finisher (MFF)

The Xerox Nuvera can include a Multifunction Finisher (MFF). There are two MFF models: the Professional
and the Pro Plus. Explore the links at the left to learn all of the ways to utilize the MFF.
Using the MFF Professional allows you to finish your jobs with features such as:
• Staple
• Collate
• Letter Tri-Fold
• Booklet Fold
Using the MFF Pro Plus allows you to finish your jobs using the same features available on the MFF
Professional but also includes an insertion module that offers these additional finishing features:
• An Insertion Tray for inserting preprinted tabs, covers and colored sheets into your job
• A 2/3 or 2/4 Hole Punch capability

How to select the MFF finishing type as the output device

Perform the following steps to use the MFF and select the finishing output at the user interface.
1. From the Copy Service, Print From File Service or Job Properties window of an inactive job, select the
Output tab.
2. Select the Stapling/Finishing FAB.
3. From the Output Location, Output Order, and Output Delivery pull-down menus, make sure System
Specified is selected.
14-8
Clearing Paper Jams.
Xerox ® Nuvera
User Guide and Training Aid (UGTA)
®